Open two terminal ( run as root )
in first terminal - ( it is to receive the serial data from device )
in second terminal-
echo "at+version" > /dev/ttyUSB0
You should see the version in the first terminal.
h. I have not yet pinned it down, but I am pretty sure it's an RAK831 reset issue.
It is not the reset issue. as it is built on sx1301 V1.0 which is not FPGA requires a reset before starting the concentrator.
In RAk831 the pin19 which is the reset pin for sx1301 when you connect to any GPIO pin, you have to pass that pin number you are using, into that script. so that script can reset the concentrator.
You can try with fresh installation of OS and then download the packet forwarder from the
then Configure account on TTN
once you extract the forwarder on raspberry pi
run the binary as sudo. first you need to configure and then you can start gateway
I had running the same lora gateway and working fine.I have tested both uplink and downlinks with it.
Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.