@aschroeder Because our previous version of rc-342 did not support webui and from then on, it will begin to support.
Posts made by Seven
RE: First steps with WisCore
We currently can't switch the location and WisCore default location is set US area, but don't worry we will soon release the next FW to support location switching.
For reset the WisCore when you press and holdthe 'SW1' button, you must wait until the led goes off which means than it has been reset successfully.
For upgrade the latest firmware, i think you hand wiscore borad can't support webui function, so you must use tftp tool to upgrade - refer to link:https://github.com/RAKWireless/wiscore/wiki/Burn-firmware-to-MT762x-Board
RE: IP Adress by default?
you can try to connect via a router - step by step:
1,use your PC ethernet port to connetc router another lan port or you can connect directly the route AP - ssid.
2, check PC ipaddr from route automatically assigns ip - assume the
ipaddr is - '192.168.0.102'
3, open tftpd on you PC and to set
4,use WisCore wan/lan port to connect router a lan port
5, WisCore have to entry uboot menu and press '2' key to entry tftp mode
6, you must be set the tftp ipaddr in the tftp option:
Chip type is MT7628A, GPIO is 6<<<
You choosed 2
2: System Load Linux Kernel then write to Flash via TFTP.
Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)
Please Input new ones /or Ctrl-C to discard
Input device IP (192.168.16.100) ==:192.168.0.123 #Must belong to the same LAN as the PC's ip
Input server IP (192.168.16.123) ==:192.168.0.102 #your PC's ip
Input Linux Kernel filename () ==:1.bin
7, press 'Enter' to download fw on wiscore
for access the web by luci
-> Do you found the the WisCore default SSID? it is usually prefixed by WisCore_
you can connect the ssid and access ip: 192.168.230.1
Note: if you use our Alexa default fw, the web is disable, wisAp is enable it is using an openwrt default web.
RE: wiscore profile patch for OpenWrt is available?
So far we have not yet done integrated a complete patch for chaos_calmer but the WisCore is based on the version of chaos_calmer to develop. So you can to download the WisCore SDK and try to combined with your openwrt branch.
Our SDK share a temporary Link: https://github.com/sevencheng798/wiscore
our SDK includes three profiles - wisAp, wisAvs, wisHgw. They were placed in the corresponding products directory.
At the same time you can refer to our quick start: