Sorry, The AT command can not change the carrier sense time.
Yes, is default value.
Sorry, if LoRaP2P, the length is 255byte.
If you want to use Arduino. Please try to set the device baud rate to 9600.
Hello, if the direct use of computer control the RAK811, the device has returned? Can you take a photo you use?
The format of the data we send is based on the Cayenne data format. https://mydevices.com/cayenne/docs/lora/#lora-cayenne-low-power-payload
@gaspar Okay, we will correct this mistake.
Can you tell me how do you get this link?
pleace download in this link:http://passport.rakwireless.com/stat/en/RAK811/Tools/Flash Loader Demonstrator.zip
The EUI may be wrong when you set up the gateway on the TTN platform.
Hi please see the document to upgrade the RAK811: http://docs.rakwireless.com/en/WisNode LoRa/Software Development/WisNode-Lora Quick Start Guide V1.2.pdf
Many users using the AT command, the first time you send a command, always find yourself sending commands without any response. Here to share with you to send the command should pay attention to the issue.
In the RAK all products that support the AT command in the document will have this introduction:
Perhaps many users did not notice this sentence, you may not understand its meaning, here to fully explain the meaning of the following sentence:
If you are using MCU to write code control device, then you need to send the command is "at+version\r\n".like this:
If you are using serial port tools on your PC to send in ASCII, you should send "at+versionENTER".like this:
If you are using serial port tools on your PC to send in HEX,you should send "61 74 2B 76 65 72 73 69 6F 6E 0D 0A".like this:
Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.