@Javierenrique00 image url)
please keep the pin 3 to on side and when the blue led blink ,press the button more than 15 seconds . you can go to softap mode again .
BTW : If you failed ,please try more times .
@abTowne please check this user manual . http://www.rakwireless.com/en/download/Video/RAK556-AP
hi ， sir
when you can not connect rak566 to the receiver rak554 , what 's the status of rak566 blue led ? blink or turn on or off?
Here is reply:
basically programs Will work out of the box.Only when you will start accessing the SPI or I2C, you need different library or Arduino core base code.
even though nrf52 and rak473 are essentially ARM processors, However their base SDK implementation of SPI and I2c drivers will be different bacuase of the different peripheral arrangement and different register configuration.
Hence even though the Arduino code will be mostly same...the internal implementation of SPI and I2C library will be different Hence you need to download the 'board variant' files in order for your code to work for a particular board….
one good example is that you will find github repo I for the itracker will have some specific board variant files.
Also another change is that of pins....for eg nrf52 may have different set of i2c pins and realtek may have different set of i2c pins....this config is also specified in the board variant files
Hope this can be helpful
If we would use different solutions, like the WiFi solution (with the Realtek chip) and Bluetooth/LoRaWAN solution (with Nordic chip), would we be able to use the same, or at least very similar base program in for example Arduino?
Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.