IP Adress by default?
i will be try this methode...I will report the results soon.
I've tried the method and the result fails, the lan and wan ports are not detected on the pc so the firmware can not be transferred from tftp.
I suspect the lan / wan port is damaged
I saw you said - ifconfig show only eth0 and no br lan information...Can you tell me current version of WisCore? Thank you !
@Seven no no dhcp ip when i plug wan port from my router
@Seven Currently still using the default original firmware from wiscore board
Do you have to place the 1.bin file in your tftp32 directory - C:\Program Files\Tftpd32? or you also can try switch lan to wan on WisCore board?
@erickfloors Confirm your PC’s static ip is set 192.168.0.2 again ?
@Seven yes..you can see on picture 2..but lan/wan port on wiscore cannot detect on my pc..1.bin added on programfiles/tftp32 folder..
@Seven Sure, i tried according to the above instruction but lan / wan from wiscore no response in pc so tftp32 can not transfer file 1.bin by lan / wan port
when you plug net-cable line into wiscore Lan/Wan port, there is no any change in the 'Network Status' icon ? or you can try disable you PC's Wi-Fi function then do it again.
yes..wifi is disable..there is no change network status icon...only show cross icon network status.
there is luci available by default? what is luci ip adress?
this is a very strange phenomenon , Can you try another PC?
what is luci ip adress by default?..
my another pc no ethernet available.. i will be check from other pc with ethernet port..
.. i think may be lan/wan port is damaged..what do you think?
cross network status
Write Firmware status ( no lan detect)
you can try to connect via a router - step by step:
1,use your PC ethernet port to connetc router another lan port or you can connect directly the route AP - ssid.
2, check PC ipaddr from route automatically assigns ip - assume the
ipaddr is - '192.168.0.102'
3, open tftpd on you PC and to set
4,use WisCore wan/lan port to connect router a lan port
5, WisCore have to entry uboot menu and press '2' key to entry tftp mode
6, you must be set the tftp ipaddr in the tftp option:
Chip type is MT7628A, GPIO is 6<<<
You choosed 2
2: System Load Linux Kernel then write to Flash via TFTP.
Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)
Please Input new ones /or Ctrl-C to discard
Input device IP (192.168.16.100) ==:192.168.0.123 #Must belong to the same LAN as the PC's ip
Input server IP (192.168.16.123) ==:192.168.0.102 #your PC's ip
Input Linux Kernel filename () ==:1.bin
7, press 'Enter' to download fw on wiscore
for access the web by luci
-> Do you found the the WisCore default SSID? it is usually prefixed by WisCore_
you can connect the ssid and access ip: 192.168.230.1
Note: if you use our Alexa default fw, the web is disable, wisAp is enable it is using an openwrt default web.
if you disable Wi-Fi, the network status icon seems to be the picture below. Can you make sure your ethernet port is good? E.g: let your computer connect to the router by lan.
my ethernet adaptor on pc working properly
screenshoot on my Hame A2 Router is working