RAK831 enclosure can't fit my kit?
received my RAK831 case today but unfortunately the RAK831 does not fit in because of the two PCB "stripes" on each side. (http://www.rakwireless.com/img/module/RAK831/pin-out.png here on the top/bottom side). The too "wings" make it to big. on this picture the RAK831 has just one of these "pcb stripes" on the top, the one on the bottom is missig: https://ae01.alicdn.com/kf/HTB1.BE8XKOSBuNjy0Fdq6zDnVXap.jpg
We will add one more note in the assembly articles.
http://docs.rakwireless.com/en/RAK831 Pilot Gateway/Casing install tutorial/Gateway casing installation tutorial.pdf
Can you remove/ cut one side of strip? Why we don’t remove because heat sink is same dimension of entire converter board but can’t fit inside enclosure! If you buy enclosure, you just need remove one side strip and don’t put heat sink on top! We have another thermal filter for you.!
In addition, to help you cut the one side strip, Pls use tweezers and cutter to remove one side strip,passed cutter over border to make it easier to snap, and snapped it with tweezers. the tools we recommend to use below one