RE: Arduino I2C with RAK WisLTE
Hi We have successfully integrated the RAK WisLTE with the Arduino.
The only problem is, I want to use an i2c port to which a sensor is connected.
When I connect the sensor with out WisLTE to the arduino's I2C pins. The sensor works just fine.
When I connect the sensor with WisLTE to the arduino's I2C pins. The Sensor stops working infact the code stops working. It hangs when a an I2C routine is there
here is the code snip
**#include <Wire.h> // Used to establied serial communication on the I2C bus
#include "SparkFunTMP102.h" // Used to send and recieve specific information from our sensor
TMP102 sensor0(0x48); // Initialize sensor at I2C address 0x48
//Temp Sensor - this is here the code halts
sensor0.begin(); // Join I2C bus
Serial.begin(115200); //Serial port for NBiot device
delay(10000); //boot time for Nbiot module
I never see an AT
As you can see from the schematic diagram, our I2C pin are connected to other things, affecting Arduino's I2C.