LoraButton quality issues and failed join



  • Hello. I just received a LoraButton and upon first connecting to USB I received an error message unrecognized device. All the solder looked okay but there was large amounts of flux. Once I cleaned the pcb the USB virtual comm began to work.

    The second problem I have run into is joining the Lorawan network. With OTAA the button fails joining continuously until I issue the at+mode=0 command. Once I issue the command the button will join successfully for a while and then begins failing again until the at+mode=0 command is issued again. Anyone have any ideas? Thanks


Log in to reply
 

Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.