Dashbutton stuck in disabled JTAG



  • I was playing around disabling the JTAG so I could use the button and leds, but I managed to get the dashbutton in a state where it will not accept JTAG anymore.

    The console is showing this:

    target_set_state : RESET Program failed
    jtag_init() failed
    main : usb disconnected

    I am using the Arduino library and altered the code in wiring_digital.c so it would not react on the empty battery anymore and put it in a disable JTAG mode.

    Is there a alternative way to program the dash button or did I just completely brick the device?

    Thanks in advance.



Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.