Dashbutton stuck in disabled JTAG
I was playing around disabling the JTAG so I could use the button and leds, but I managed to get the dashbutton in a state where it will not accept JTAG anymore.
The console is showing this:
target_set_state : RESET Program failed
main : usb disconnected
I am using the Arduino library and altered the code in wiring_digital.c so it would not react on the empty battery anymore and put it in a disable JTAG mode.
Is there a alternative way to program the dash button or did I just completely brick the device?
Thanks in advance.
I'm in the same situation.
Did you find out how to "unbrick" the dash button ?