RAK811 Sensor Node - using Arduino IDE
I have successfully installed the 811 Arduino Library into my Arduino IDE. The device appears on COM46 on my machine successfully and I can see traffic on the debug window. However, what do I set as the Board type (Under Tools->Board)? see nothing obvious to select or install on Boards Manager.
@patmolloy In this moment there wasn't support by arduino.
You can only access by AT-Commands.
But it would the best choice if we can access the tracker or sensor node directly by arduino.
I hope RAK listen to us
I am trying to port the RAK811 to the Arduino Core, but I am having some problems wanting to use the module Lora with the Lmic (https://github.com/mcci-catena/arduino-lmic) or Lora (https://github.com/sandeepmistry/arduino-LoRa) libraries with pins RADIO_RF_CRX_RX PB_6 //CRF3 (ANT_SWITCH_TX_BOOST), RADIO_RF_CBT_HF PB_7 //CRF2 HF (ANT_SWITCH_TX_RFO, RADIO_RF_CTX_PA , any help is welcome
Hello, here is the design schematic of the RAK811 module. I am very much looking forward to using RAK811 on Arduino.RAK811 SCH.pdf