WisNode LoRa update problem
-
I can not update firmware.
The pins 3V3 and BOOT are bridged , but in the STMFlash Loader "No response from the target" is displayed and it does not proceed.
Please tell me how to handle it.
-
Please take a photo for you WisNode LoRa. Thanks
-
Thank you for responding.
I send pictures and screen captures.
-
I have the same board revision and jumper settings as you and the exact same problem. I can connect it to a serial console, and in boot mode when resetting it responds with
<BOOT MODE>
Welcome to RAK811-NHowever no matter what I try, the flash utility refuses to connect so I can perform a firmware upgrade with the same error message as above. I've been tearing my hair out over it all day.
-
hi, the RAK811-N is different with RAK811,please see the RAK811-N upgrade firmware manual. http://docs.rakwireless.com/en/RAK811-N/Application Note/RAK811-N Firmware Upgrade manual.pdf
-
Hi , this is the difference between RAK811 and RAK811-N
-
Thank you very much.
Update succeeded.
Do you support AS923? If so, which firmware should be applied?
-
What firmware for the RAK811-N is there available then? There is nothing listed under it's category on the document site, and RAK811 firmware fails to flash, and the 811-N doesn't connect to LoraWan gateways in the AU 915 frequency. This board seems crippled useless to me right now.
-
The RAK811-N firmware based on LoRaWAN 1.0.2 will be released on the official website this week