RAK831 & RPi Converter Board
I am trying to use the LoRa gateway and the converter board with my Pi but have had no luck so far.
Is there any detail available for the converter board? The version I was shipped has two jumpers on it, but it's unclear what they are for. It appears they may allow you to select which GPIO pin is used??
Is there also a description of what the status LED on the 831 indicate? They are labeled GPIO 0-4.
Does the converter board work, or should I use a breadboard?
The RPi Converter Board Work is no problem, we have verified. You may not have initialized RST pin, please follow this tutorial: https://www.hackster.io/naresh-krish/getting-started-with-the-rak-831-lora-gateway-and-rpi3-e3351d
@rakadmin I will try that again.
Can you elaborate on the jumper pins or the status lights?
Hi,The jumper pin is GPS RX and TX to RSPi 3 TX and RX。if you want use GPS，can jump.