HI! I am actually working with the library for arduino of RAK811 modem, for second band of us915 frecuency and ABP mode. The module works fine; but i have some doubs about "fCnt". The fCnt that i receive is always on "0". I think that maybe one of the next commands maybe restart the counter:
2- at+set_config=dev_addr:" + DevAddr + "&nwks_key:" + NwkSKey + "&apps_key:" + AppSKey?
can you tellme wich are?
@coeus I think your problem is that OS X (as well as virtually any operating system besides DOS and Windows) sends a line feed if you press enter. RAK811 original AT firmware expects DOS style line endings (carriage return, followed by line feed). Screen under OS X sends newline only. You can try CuteCom. I use it under Linux, because you can select the line endings there .
@Charles great suggestion!, actually the main circuit on the tracker with voltage meter can drain 132 uA (100% of the time); how many current your circuit can drain? (for 100% of the time and when you activate the EN pin)
We made same testing but pls note we put the antenna in vertical position on table. The performance should be fine.pls see the snapscreen! Can we resend an antenna to you for testing again if you like?
Currently, that is not my problem. What I need to do is figure out how to get the LoRa Button back to a factory default setting, so I can configure it through the serial interface. Right now, I can't communicate to the device at all.
In fact I saw that the boot jumper was in the wrong position. Yesterday I made a backup copy of the flash. When putting it right, I cannot flash the Arduino any more. Seems that Serial0 is still connected to the WisMode who answers when flashing occurs.
I made a duplicate sd (and some backups) and stopped the Loriot gateway after booting the duplicate.
There was no uninstall.sh although they mentioned it.
I manually moved/renamed the /opt/lrt and rebooted.
The TTN gateway was easy to install with the link you provided.
I can swap the sd cards now to choose the network Loriot or TTN.
Looks like your connection to RAK Support Center was lost, please wait while we try to reconnect.